|
Well I took the trans out and everything. Here what I found. the throw out bearing stuck to the tremec casing that it rides on, and cracked the case and blew the slave cylinder.
What I did/am doing to fix the problem. I reindexed the bellhousing,reset the pivot ball to 4 3/4" from back of engine saver plate, inspected the flywheels (everything good) and installed it, inspected the clutch (no damage) and reinstalled it, Inspected the pressure plate(no damage) and reinstalled it, inspected and reinstalled the stock clutch fork, installed a brand new throw out bearing, and installed a brand slave cylinder. I also installed a new case on the tremec. I have not installed the trans,drive shaft yet.
Will update the post when i do
|