Quote:
Originally Posted by sweetbmxrider
When I cut braided, I tape about a 2 inch section and cut in the center of it. I get the cutoff disc spinning full speed and then go straight and quick through the line. If you start effing with the end strands, start over cause they will never go into the fitting correctly  |
Same deal. 2" section, tape, cutoff wheel spinning fast. If it frays just a little I can guide it in with a screwdriver, and when I thread the female hose end onto the male end I use some assembly lube or ATF on the threads. The soft vise jaws and AN wrenches help keep them nice, too.