NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post

Lt1_8U · 01-08-2013, 09:16 AM

Hahaha nice! How's it line up in there with the bellhousing? I don't think I need to cut. I have the trans as high as it can go without pushing against the floor. At this height the poly mount on the trans is about an inch higher than the crossmember. I will buy a digital protractor to check my driveline angle though.

That picture is before I trimmed the shifter hole, so it's not sitting up all the way.

01-08-2013, 09:16 AM	#6
Lt1_8U Join Date: Sep 2006 Location: north jersey Posts: 1,680 iTrader: (3)	Hahaha nice! How's it line up in there with the bellhousing? I don't think I need to cut. I have the trans as high as it can go without pushing against the floor. At this height the poly mount on the trans is about an inch higher than the crossmember. I will buy a digital protractor to check my driveline angle though. That picture is before I trimmed the shifter hole, so it's not sitting up all the way. Last edited by Lt1_8U; 01-08-2013 at 09:19 AM.