[V]

I am looking for a 82-92 chassis to use for two things. First I may want to use the driver side upper frame section as a replacement on my car so that front corner must be good and rust free. Then I also need the back half for mock-up/repair of my hatches. 1/4s can be shot and floor pan can be rusted, I just need the back 1/4s to be square and not damaged from a rear end accident.

I'd take half a car if one is already cut across at the doors. Or I'll come out and cut it myself if the front was crashed. I'd prefer a NON-accident car just to ensure the unibody is straight and square though.

Pictures are a must.

a FIREBIRD is preferred, but a camaro could work.