NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post

LS1ow · 05-23-2017, 03:15 PM

As you guys know, i have an on going project

http://www.njfboa.org/forums/showthread.php?t=67204

^^^ link to main build thread

^^^

With the interior pretty much all back together, i have decided the dash needs to come out again. And while doing so, id like to tidy things up a bit.

What is the "proper" way to go about the remaining pieces of wire after removing the ones you wont need?

For instance, i am ditching the hvac stuff and well as the cd changer in the back of my car. Rather than just leaving them unplugged, i plan on cutting them back as close to the "main" harness as possible. But thats were im a bit confused.

I obviously dont want to leave exposed wire just hangin out, but is just throwing some electrical tape over the ends of them the real way to do it?

05-23-2017, 03:15 PM	#1
LS1ow Power Member / trans break does not equal transbrake Join Date: May 2009 Location: The Meadowlands Posts: 4,533 iTrader: (15) Social Networks:	Wire Removal As you guys know, i have an on going project http://www.njfboa.org/forums/showthread.php?t=67204 ^^^ link to main build thread ^^^ With the interior pretty much all back together, i have decided the dash needs to come out again. And while doing so, id like to tidy things up a bit. What is the "proper" way to go about the remaining pieces of wire after removing the ones you wont need? For instance, i am ditching the hvac stuff and well as the cd changer in the back of my car. Rather than just leaving them unplugged, i plan on cutting them back as close to the "main" harness as possible. But thats were im a bit confused. I obviously dont want to leave exposed wire just hangin out, but is just throwing some electrical tape over the ends of them the real way to do it? __________________ 99 Z28 - SBE LS1/60e Motor - 10.84 @ 128 - 1.47 60' Nitrous - 10.16 @ 132 - 1.40 60"