Quote:
Originally Posted by Blackbirdws6
My Dad mentioned, and you as well, there is a good debate on what to do first. Pops decided to put the epoxy (or etching primer) on and then the filler. He said if while sanding he hit any bare metal, he would hit it with epoxy primer (or etching) again. I don't recall the sanding grit but he seems to keep mentioning 180.
|
The arguments here are crazy. Some say never to put filler over etching primer while others say its fine.
A friend of mine who does body work, suggested epoxy only. Epoxy over bare metal, filler, then again with epoxy. Biggest point he made was to make sure the metal was warm so condensation wouldn't get trapped between the primer and filler or the bare metal and filler
__________________
1983 camaro- Scrap
1988 camaro- Also scrap
'05 Silverado- You guessed it, scrap
1988 TRX 250R- Ported w/ high compression on 110 octane- Out 60' your LT1
Jersey Shore Street Car Takeover (JSSCT) Founder
Quote:
Originally Posted by LS1ow
and once i get PHB, what do i ajust it too?
|
Quote:
Originally Posted by Jersey Mike
Seven.
|