Quote:
Originally Posted by ThoR294
I did the whole pendulum thing to center the rear when I first installed that bar.
On LS1TECH, I was told to try and measure the transmission angle from the shifter plate. i may be getting a bad reading from the transmission under the output shaft. Also, was told to have -2 total angle... so if the trans is -3 the rear should be -1 and that should work for me. so I am going to try to pull the console out on my uncles alignment rack and do it AGAIN... and pray to the vibration gods
|
If you have -3 off of the trans and -1 off of the rear you have -4.