[foxriderry]

OK so i started my SJM line lock install. Everyone says the directions are clear and its an easy install ... i guess I'm just dumb haha.

So the directions refer to PVA and LLA lines... not quite sure what those are, and i don't know which lines to get rid of and which ones to plug in where on the line lock and proportioning valve.

So my question is ... does anyone have a brake line diagram that might show this information? If not can anyone guide me in the direction of which lines to remove? Is there anyway to determine which lines are for TCS/ABS (cause i imagine i can rip those out) and than using process of elimination figure out where the other three go. If anyone else has any other ideas I'm all ears.