yea, the seat brackets I made that I was showing you on Sunday, I actually Used a Lincoln 140T (I think that was the model) welder and used flux core because we didn't have the gas cylinder setup yet (the welder was about a week old at this point).
http://www.lincolnelectric.com/en-us...incolnElectric)
and since you mentioned the seat brackets that we were talking about.. here is a link to the ones I built that we were looking at.
the photos and write-up start 1/4 of the way down this page on my website
http://www.freewebs.com/iroczman15/workdonein2011.htm