Quote:
Originally Posted by IROCZman15
Of course not! I currently have no idea what I’m doing !!!
All I did was cycle the key or restart the car if the engine stalled (like in the video). The holley sniper manual says to just cycle the key to reset TPS. didn't see a wizard for it?
|
My bad, I keep making the bad assumption all holley products have similar software.
https://forums.holley.com/showthread...46-TPS-Autoset
"Once the engine is up to operating temperature, the idle speed can be set to what was configured in the Wizard.
To do this, open up the Initial Startup gauge screen that was used in section 17.0. With the vehicle in neutral,
adjust the idle screw until the IAC Position reads between 2 & 10%. While adjusting the idle speed screw, if the
TPS Position begins to read higher than 0%, cycling the ignition switch will recalibrate the TPS back to zero.
NOTE: Do not attempt to set the Target Idle Speed and IAC Position until the engine is above 160°F!"