NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post - Seeking some advice before ordering a Moser 12 Bolt

Blackbirdws6 · 12-15-2018, 06:41 AM

No need to go 5/8" on the studs. That's overkill and will not work with most wheels. 1/2" will be fine for whatever you are doing. If you don't plan on running a dedicated drag wheel with shanks at the strip, grab some acorn, extended shank lugs. I'm fairly convinced my stud bending wasn't helped by the fact my car is heavy with a good amount of power running acorn lugs. Billet specialities makes them and I have a set in my garage if I decide to just run the car with street tires.

12-15-2018, 06:41 AM	#8
Blackbirdws6 Lord of the rings / 10 Second Club / Meet Coordinator Join Date: Aug 2004 Location: Millstone Township, NJ Posts: 6,353 iTrader: (3)	No need to go 5/8" on the studs. That's overkill and will not work with most wheels. 1/2" will be fine for whatever you are doing. If you don't plan on running a dedicated drag wheel with shanks at the strip, grab some acorn, extended shank lugs. I'm fairly convinced my stud bending wasn't helped by the fact my car is heavy with a good amount of power running acorn lugs. Billet specialities makes them and I have a set in my garage if I decide to just run the car with street tires. __________________ 97 T/A Ram Air Convt Forever dyno queen / 777rwhp 662 rwtq @ 17lbs / 10.2 @ 140 '24 Corvette Z06 17 Sierra 2500HD Dmax 81 Turbo TA Last edited by Blackbirdws6; 12-15-2018 at 06:41 AM.