Thread: Not this again.
View Single Post
Old 11-10-2016, 10:32 AM   #96
LS1ow
Power Member / trans break does not equal transbrake
 
LS1ow's Avatar
 
Join Date: May 2009
Location: The Meadowlands
Posts: 4,512
iTrader: (15)
Social Networks:

Results.

Here is my solution to ballin' valve covers not being cost effective at this time.

$7 can of VHT Wrinkle black and $38 billet coil brackets

Not as "Wrinkley" as a power job would be, but it like it better than just flat black. Its deff got some texture to it.

Ive painted small parts on my jeep with it before. What i did was follow the instructions on the can. Which is 3 heavy coats one right after another. 1 coat side to side, 1 coat up and down, and 1 coat on a a diagonal. It goes on smooth and when it cures it get the texture. The 3 direction coating makes it wrinkle in a few directions, thus a better finish.

I threw them in the oven for 20 mins @ 200 right after laying the paint down.





__________________
99 Z28 - SBE LS1/60e
Motor - 10.84 @ 128 - 1.47 60'
Nitrous - 10.16 @ 132 - 1.40 60"

Last edited by LS1ow; 11-10-2016 at 10:32 AM.
LS1ow is offline   Reply With Quote