Thread
:
92 Firebird
View Single Post
08-29-2016, 01:03 PM
#
84
PolarBear
Ebearnezer Scrooge/Power Member/Lips
Join Date: May 2006
Location: Hamilton, Mercer county
Posts: 4,141
iTrader: (
16
)
Got my Y pipe all fabbed up this weekend, it is mostly a Magnaflow Y pipe for an L98 application. I figured it was a great starting point, and it was, I probably only have 10 hours or so in all the fitting and cutting of everything. It is all stainless, down to the flanges. I do still have to weld it all up, just need to clean up the garage a bit more so I can get to the TIG and then use my MIG cylinder as a back purge.
PolarBear
View Public Profile
Send a private message to PolarBear
Visit PolarBear's homepage!
Find More Posts by PolarBear