[GhostDakota]

I'm selling my v2.0 projectors (2nd set I've made). I built these a couple years ago and they work great. SO MUCH brighter than the stock lighting. Obviously there is no warranty. The driver side cutoff shield sticks and causes a bit of a hazy cutoff. It doesn't bother me so I have not fixed it. You can see this issue if you search via Google for "MH1 sticky cutoff shield". There are ways to fix it but I didn't want to take the kit apart. The lexan was cut using a bandsaw and then slightly sanded around the edges to make it look better. I don't have a dremel lol. I think they look fine personally.

What you get:
-Full headlight assembly which includes:
--Morimoto MH1 v4.1 Projectors (Bi-xenon - HID high and low!)
--Morimoto shrouds
--VVME 5000K 50/55w H1 capsules (bulbs)
--Factory Jeep Housing
--Lexan lens
-Morimoto 50w HID ballast
-VVME 50w HID ballast
-Wiring harness (Plug and play with 2 grounds needed, 1 negative batt. cable, one

YouTube video here: http://www.youtube.com/watch?v=qBBzCB-9CvY

Photos here:

As you can see they are dirty and still need some sanding to get the ends perfectly flat:


More shots:


















Output shots...

Low:


High:


Low:


High:


I'm asking $350 obo.