|
check for play tailshaft bushing to yoke @ rear of transmision.
when trans replaced, the trans wasn't hung from input shaft was it? possible slightly bent input shaft?not likely though.
also check to make sure locating pins in back of block are through the trans, if pushed into block can cause trans to be off-center(then the input shaft will be forced to ride @ a slight angle to engine,tearing up pilot bearing and possible clutch disc to pressure plate contact in nuetral
__________________
Quote:
Originally Posted by SRGN
I never pulled into the staging beams at the track and saw a dyno in the other lane.
|
South Jersey Racecraft
|