View Single Post
Old 05-01-2017, 09:59 AM   #3
wretched73
 
wretched73's Avatar
 
Join Date: Nov 2007
Location: Jackson, NJ
Posts: 1,715
iTrader: (2)
Quote:
Originally Posted by sweetbmxrider View Post
What is currently on the rear? Do you have rubber hoses? The hard line and braided hoses are obviously the complete setup, if that is what you need then grab it. You will have to manipulate the hard lines to match the 12 bolt routing and overall length. 4th gen rears wider or narrower? I guess that is the only problem you'd run into. Could make your own lines if you are up for it.
4th gen rear is a little wider (.5"-1" on each side IIRC)
__________________
1983 camaro- Scrap
1988 camaro- Also scrap
'05 Silverado- You guessed it, scrap
1988 TRX 250R- Ported w/ high compression on 110 octane- Out 60' your LT1

Jersey Shore Street Car Takeover (JSSCT) Founder

Quote:
Originally Posted by LS1ow View Post
and once i get PHB, what do i ajust it too?
Quote:
Originally Posted by Jersey Mike View Post
Seven.
wretched73 is offline   Reply With Quote