Short of a vacuuming, bottle mounting and stuff is done. Which exception of the blow down tube, bc missing.
Window Switch and progressive controller mounted on the side of the bottle bracket for easy access of use. Ran feed line through the cup holder to avoid any crazy bends in the line. Figured may as well run the wires for the heater pressure sensor there as well. Loomed everything the best i could. There is a ton of wires in a small area, all of which are going different ways. so its a bit sloppy. May redo at some point, but good enough for now. Going to get a small piece of PVC and cut it in half long ways to create like a tunnel for the wires that run under the console, and then recarpet over it. As you can see i cut off to much carpet between bottle mount and console.