View Single Post
Old 10-24-2017, 04:49 PM   #1
Franksride
 
Franksride's Avatar
 
Join Date: Oct 2017
Posts: 12
iTrader: (0)
Question 79 Camaro block terminal question

Hi everyone -
I inherited my brothers 79 Camaro Berlinatta recently after 10 years sitting in his garage.
He never got to finish the work he started and it’s now a tribute project to him. We started by checking if the engine could be hand cranked after oiling each cylinder and letting it sit for a week. It turned fine. Next we got a new battery to replace the one that made a big mess in the engine bay. Cleaning the surface rust is the least of the problems. The starter ended up being bad so we started changing the braking system. After removing the booster assembly we found a Terminal block just to the right of the booster for the engine harness. (Fig.1) http://www.njfboa.org/forums/attachm...1&d=1508881686
Each terminal has some black semi-malleable crud on it. My question is, can this be cleaned off and then sealed with a good silicone? The wiring is in good shape but it will be tested before the new engine goes in.
Your help is much appreciated.
Thanks….
- Rich
Attached Images
File Type: jpg bloktermnl3.jpg (19.8 KB, 29 views)
Franksride is offline   Reply With Quote