View Single Post
Old 10-04-2017, 07:50 AM   #19
WildBillyT
Ayatollah of Rock N Rolla / Admin
 
WildBillyT's Avatar
 
Join Date: Mar 2006
Location: Parts Unknown
Posts: 12,573
iTrader: (10)
Quote:
Originally Posted by cycomiko View Post
An update. The new line is in and is nice and snug but I still can't get fluid to the rear. I've tried everything gravity vacuum etc. It was killing me then I decided to check the two fittings on the master and wallah the front bore fitting is not pushing fluid and the master is weeping behind it also. Is it a defective unit? Did I not bleed all the air out? Is it toast? Should I try to bleed it or just put the old one back on and return it. The old one was fine......
You are talking about a leak between the booster and master, correct? If so, I believe a seal in the master is bad.
WildBillyT is offline   Reply With Quote