So 2 problems have been uncovered in the past 24 hours.
1. I must have messed up the nitrous wiring, nothing is getting power. Going to check over everything tommorow and if need be just start from scratch and build new harnesses.
2. Car has a coolant leak from the thermostat housing. Ended up draining coolant and pulling housing off. Chased threads to make sure everything was good. (Tiny aluminum bolts into aluminum housing) and reapplied a gasket and torqued down. Refilled coolant. Still leaking. Upon further inspection, housing has a crack in it. New billet unit has been overnighted from summit.
Didn’t want to dig into nitrous wiring tonight, want to do it all in 1
Shot so I don’t mess anything up. So instead I spent another hour or so redoing the carpet that was removed to do the cage. Doing Ozite again so it’s not terrible, driver side and passenger side seat and foot area done. Rear hatch and back seat area will be completed after nitrous problems are solved
__________________
99 Z28 - SBE LS1/60e
Motor - 10.84 @ 128 - 1.47 60'
Nitrous - 10.16 @ 132 - 1.40 60"
|