NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post

PolarBear · 07-05-2013, 07:28 PM

I have a small air water separator and then a post filter setup for my air setup, but it is close to the compressor and the iron pipe I have used is only about 2 feet worth. I am planning on putting together a larger setup, but I am not sure how many sections of pipe to use. I was thinking that 3 sections of 4' pipe with a ball valve at the bottom of each section to drain water that has collected, then attach that all to the separator that I have already created. I would have the pipe go up, then down then up then connected to my existing setup.

Is this enough ups and down? Currently I start spraying water after only a few cycles of the compressor I start spraying water either out of my tools, or the nozzle of the media cabinet.
Thought/opinions?

07-05-2013, 07:28 PM	#1
PolarBear Ebearnezer Scrooge/Power Member/Lips Join Date: May 2006 Location: Hamilton, Mercer county Posts: 4,141 iTrader: (16)	Water separator/drier I have a small air water separator and then a post filter setup for my air setup, but it is close to the compressor and the iron pipe I have used is only about 2 feet worth. I am planning on putting together a larger setup, but I am not sure how many sections of pipe to use. I was thinking that 3 sections of 4' pipe with a ball valve at the bottom of each section to drain water that has collected, then attach that all to the separator that I have already created. I would have the pipe go up, then down then up then connected to my existing setup. Is this enough ups and down? Currently I start spraying water after only a few cycles of the compressor I start spraying water either out of my tools, or the nozzle of the media cabinet. Thought/opinions?