[Blackbirdws6]

Busy day yesterday. I was only planning on building headlights but decided to get a few things done on the car.

I replaced the O2 sensors and wideband sensor. I've passed quite a bit of oil past the old sensors so a fresh set made sense. The MightMouse PCV can is hooked up. Factory PCV port gets connected to the inlet of the can. Outlet has a check valve which goes to the intake port below the throttle body. Passenger valve cover just gets a oil fill cap (no breather) and drivers side gets the breather. Hopefully it works as well as they say it should.

Got the car up to temp and AFR is looking good now. Coolant system took forever to bleed and I think needs a little more.

Now these roads need to clear up so I can take it for a ride!