NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post

LS1ow · 06-19-2017, 04:57 PM

Upon further inspection, Pin H is the signal for the M6 Reverse lights. Which goes from C200 all the way to the back of the car.

Since the A4 reverse lamps are run off the Body harness and not the engine harness like the M6 is, i should be able to snip and cap the signal wire from pin H of C200 were it goes into C400 at at the taillight plug, and just connect pin D from my shifter plug to taillight plug?

06-19-2017, 04:57 PM	#60
LS1ow Power Member / trans break does not equal transbrake Join Date: May 2009 Location: The Meadowlands Posts: 4,513 iTrader: (15) Social Networks:	Reverse Lamp Shens Upon further inspection, Pin H is the signal for the M6 Reverse lights. Which goes from C200 all the way to the back of the car. Since the A4 reverse lamps are run off the Body harness and not the engine harness like the M6 is, i should be able to snip and cap the signal wire from pin H of C200 were it goes into C400 at at the taillight plug, and just connect pin D from my shifter plug to taillight plug? __________________ 99 Z28 - SBE LS1/60e Motor - 10.84 @ 128 - 1.47 60' Nitrous - 10.16 @ 132 - 1.40 60"