|
I'm way up north in bergen county, zip 07624 to be exact.
I have the pipe off the motor and its all held in place right now with hose clamps so it can be tacked then test fitted one last time before being fully welded. The alignment isn't too much of a concern. The brace holds the flange so that its vertical. The car will be a daily driver, all stock so no need for fancy exhaust. I just had to make this myself since it is not available new anywhere. The factory has this basic setup with a small flex section. The original pipe which was poorly repaired to begin with failed due to 2 broken motor mounts.
|