Had some time yesterday so i went back and redid the handle bar/bumper support in the DOM tube.
Decided to change it up a bit instead of doing 2 90*ish bends like the template. Came out pretty good. Still has to be fit to the plates, but the shape is on point. Did everything by eye on the first side, then used an angle finder to replicate on other side.
Front bumper peak thing comes out to a 22* bend. then a 50* bend to slope it back to the headlight bracket pick up, and then from there a 60* bend to get it straight on to the plates.
Today will prob weld the needed tabs on and get it fit in place. Im not going to weld in place until the rad support is done