Thread: Not this again.
View Single Post
Old 07-12-2019, 06:54 AM   #2251
LS1ow
Power Member / trans break does not equal transbrake
 
LS1ow's Avatar
 
Join Date: May 2009
Location: The Meadowlands
Posts: 4,512
iTrader: (15)
Social Networks:

Started to finish the UMI drag bar bar install and just have a few questions for some of you that have already.

1. for bushing location, just run the equidistant from say backing plate/tire on both sides? on any section of the bar that is straight? assuming closest to outside is best here.

2. It says nothing in the instructions about the pitch of the bar. It shows how to set it up and preload and everything, but not were to start at. Should the bar be flat? (0 degree) or match the pinion angle?
__________________
99 Z28 - SBE LS1/60e
Motor - 10.84 @ 128 - 1.47 60'
Nitrous - 10.16 @ 132 - 1.40 60"
LS1ow is offline   Reply With Quote