thanks man, I had a pretty well shaped plan for how the next 3 months would play out, but unfortunately things took an unexpected turn. roll bar can wait. I'll need the $ for other life things instead. The engine will still be built since I paid for 2/3 of it already and the block/parts are ready to be assembled. pat will send over photos once they get started.
In the meantime, I will be proceeding so relocate the battery to the rear of the car and install the master kill switch in the tail-light. After much research, I THINK I have come up with a proper gameplan.
I have attached a schematic that I drew, so if anyone sees anything wrong with it please let me know. Some people have had luck with not using a battery --> engine block ground wire, and just using chassis grounds, but I want to eliminate all possible sources of faulty electrical issues, so I plan on running one. Also, in the Ron Francis wiring booklet, it says to run this important ground wire.
Unsure if I am going to use welding wire, or just buy some SGX or SXL cable?
Also unsure about a plastic vs a metal battery box. It will be going sideways in the area of the trunk where the spare tire used to be mounted. I'll have to fab up a flat/level plate for it to sit on, and also mount it to the "frame-rail" under the car. Even though its an AGM optima battery, I'll have the box be vented. Thoughts about the best box to use?
Not wanting to put the dual "dump/charge? terminals outside the car like most drag cars have... instead I'll have a junction box/jump terminal mounted under the hood for the + jump spot. I have read that using a mega fuse on this line is a good idea.. but NOT to use any fuse on the positive battery/kill switch --> the starter wire since amps get high and it would blow the fuse often.
Double pole, single throw kill switch mounted in the rear drivers side tail-light.
Will ground both cylinder heads to eachother and then the block to the chassis, as well as the block back to the battery negative... and the battery negative to a chassis ground at the rear of the car.
a question I have (and may call holley about) is if I do turn the kill switch off often, when parking the car for short term, will this cause the "memory" and "settings" in my Holley Sniper EFI unit to be erased???