Thread: Not this again.
View Single Post
Old 10-11-2017, 05:48 PM   #1139
LS1ow
Power Member / trans break does not equal transbrake
 
LS1ow's Avatar
 
Join Date: May 2009
Location: The Meadowlands
Posts: 4,513
iTrader: (15)
Social Networks:

Angry

Started wiring the EWP today using the harness they sell, which is just 4 wires off a relay.

The relay has 1 blue, 1 black, 1 green, 1 orange wire.

Blue: to blue wire off wp

Black: ground, but there is a black wire off the EWP. Is the EWP itself grounded? Do I run the black wire off the relay to a ground as well the black wire off the EWP to the ground ?

Orange: 12v source, so any recommendations ? Relay is right by fuse box. Can I just run a wire with an eyelit to the same post that the cable that powers the fuse box from the starter runs to? Or is that to much for a small wire

Green: key on source, any one in specific I should pick up off?
__________________
99 Z28 - SBE LS1/60e
Motor - 10.84 @ 128 - 1.47 60'
Nitrous - 10.16 @ 132 - 1.40 60"
LS1ow is offline   Reply With Quote