[LTb1ow]

The place that rigged up my quiet catted x pipe was a Meineke Center in Colonia NJ. Believe the owner was Bryan and he did it for a few hundred IIRC.

The trickiest part and you touched on it, was the "frame" rail driver side where the fuel and brake lines run. You will need to dimple the exhaust pipe in a large area to clear this and most places do not have the means to do that. If you look at any ORY for LT headers they all have that flat spot placed in them to clear.

If you do go this route, have some form of quick connect at the header, either V bands, or flanges and again at the rear half by the mufflers.

Be prepared for crappy ground clearance and a smelly/loud car. Also, if you ever want a chassis mounted torque arm, you won't be able to run an X pipe.

Hate to be a broken record, but just be aware of what you are getting into.