View Single Post
Old 02-07-2020, 11:38 AM   #4
WildBillyT
Ayatollah of Rock N Rolla / Admin
 
WildBillyT's Avatar
 
Join Date: Mar 2006
Location: Parts Unknown
Posts: 12,573
iTrader: (10)
Quote:
Originally Posted by BonzoHansen View Post
is there any sealant on that OPS? you should have plenty of firewall clearance to run it there but it may need to turn more. it might even fit as shown. A big cap HEI fits no issue.

I like to install all that extra stuff after the engine is in the car, but that's just me. less to break/scratch/get in the way, less weight, easier to move around. all that.
I was going to say this too- I think the OPS should have sealant on it. If you can't find a smaller OPS I *guess* you could also use braided hose to relocate it.

Regarding the breathers, those valve covers do have baffles on them. I think you can probably run both in the back without issue. Only possible downside is that oil may get thrown back there during hard acceleration. With no PCV you might get a little bit of oil mist anyway.

Last edited by WildBillyT; 02-07-2020 at 11:40 AM.
WildBillyT is offline   Reply With Quote