View Single Post
Old 08-11-2006, 02:04 AM   #25
automotivebreath
 
automotivebreath's Avatar
 
Join Date: Jun 2006
Posts: 9
iTrader: (0)
Quote:
Originally Posted by hardline_42
How about a small write-up on how to do it? ...
I mark the bore diameter on the head then I draw a line on the deck surface at a right angle to the intake gasket surface right between the valves up to the gasket area. I then cut a slot 0.060" wide a 0.060" deep with a ball end mill being careful not to damage the head gasket area. I widen and deepen the groove into the combustion chamber cavity to 0.125" with a hand held hacksaw blade and a triangle file.

automotivebreath is offline   Reply With Quote