View Single Post
Old 03-09-2014, 12:42 PM   #184
bigz28man
 
bigz28man's Avatar
 
Join Date: Jun 2011
Location: Manahawkin New Jersey
Posts: 608
iTrader: (1)
So I've decided to lower this car a little more. I'm going to pick up BMR's 1"lowering a-arms and I just picked up 3 ft of 1/2 heater hose to do the heater hose mode. Just have a couple of questions.

1. What, if any needed lubricant can I use to slide the heater hose onto the rear springs?
2. Even though doing this mod is fairly simple how does the heater hose lower the car? It appears in theory that it would raise the rear end.
3. If I choose down the road to remove the heater hose from the springs is just a simple cut and remove?

Thanks guys.
__________________
97' Z28, M6 w/ golen engines 396 Lt1, rpm transmission level 6 t56, moser 12 bolt eaton posi w/ 4.11 gears, Hooker super comp long tube headers ory-pipe, slp loudmouth 1 .Full BMR suspension, Bilstein shocks. Torqhead 24x conversion.
02' SS, M6 BMR lowering springs, adj. pan-hard bar, Bilstein shocks. Lt1 front end conversion. Ford 9"
bigz28man is offline   Reply With Quote