View Single Post
Old 02-22-2020, 10:41 PM   #25
IROCZman15
Meet Coordinator
 
IROCZman15's Avatar
 
Join Date: Dec 2004
Location: Roxbury, NJ
Posts: 1,693
iTrader: (6)
PolarBear: yea the price seemed pretty high, and I am in NO real rush to have TCC lockup right away. Good to know that I can probably go with a more affordable kit that will do the job just fine. cool. thanks



converter is being shipped and should arrive this week. Then I can install it, install the trans, the trans fluid lines, new Lokar locking dipstick, Lokar TV cable, and the Dennys Driveshaft. hopefully that should get me a chance to do a road test.

I did begin to install the locking dipstick, and needed to drop the trans pan to do so. it clicks together and the lower part has a locking threaded portion design. it also comes with a click-in plug for if you need to take the trans out of the car or transport it etc.







I installed the Lokar throttle cable and its sniper bracket. I forgot to take a close-up photo of it installed, but it can be seen in other photos below






The coolant overflow/expansion tank arrived and I got it mounted up.



Spent a LOT of time running wires, tucking them in split loom after labeling them and building the relays for the two electric fans. I tested the fans too by changing the on/off parameters in the sniper handheld, and both fans turned on and off when I commanded them to; success! Since I have a 160 thermostat, the engine builder recommended Fan 1 come on at 190 and turn off at 160. Fan 2 come on at 210 and off at 280(***correction, I meant off at 180!! ) . With the high volume water pump, Evans coolant, big 2 core aluminum radiator, no AC, and intact air dam.. I am hopeful that I will not have any cooling problems.


It was nice out today so I pushed the car out in the driveway and some neighbors came by to check out my progress, and they helped me put the hood back on too. After that I gave the car a much needed wash and took some photos.



























I am happy with the progress so far.
I will need to re-learn the car and what the new powerplant wants, and will have to work on not-frying the rear tires before adding in Lockup. My budget is getting diminished currently, and I was really hoping to be able to find/buy a nice set of wheels/drag radials or slicks. Also would still love to have the 6 point roll-bar done one day, somehow.







Now that the hood is on, I can get a proper measurement for an air cleaner/filter setup. I really don't think I am digging the typical round circle air filter for this car. I am kinda leaning towards the oval shaped look. I know its not typical 3rd gen fbody, but I am thinking it might look pretty good with the my under-hood components. something like:

https://www.summitracing.com/parts/ems-ms215-96p
or
https://www.summitracing.com/parts/ems-ms215-95ca
or
https://www.summitracing.com/parts/bsp-15420
or
??? thoughts??




took a short video walk-around
https://www.youtube.com/watch?v=7TBbf6jNX5w&t=1s
__________________
1987 IROC-Z - modified
http://www.freewebs.com/iroczman15/

Last edited by IROCZman15; 02-23-2020 at 06:17 PM.
IROCZman15 is offline   Reply With Quote