Quote:
Originally Posted by sweetbmxrider
i have an end link for a late model ram 1500 sitting on the bench and the pre drilled but not tapped hole seems to take a 7/32" bit. hope that helps
|
Quote:
Originally Posted by //<86TA>\\
the small zerk fittings are 1/8 npt, so you need to drill the proper hole, which is not 1/8", for somereason i think its "R" but i have to check. Just make sure the threaded part of the zerk does not come in contact with the sway bar
Checked, it is an "R" bit size
|
Thanks for the specs, guys. It helps me a lot. I think the zerks I have are 1/8 npt, but will have to double check.