Redid the valve covers in VHT wrinkle black after welding on the bungs, love this finish.
Pic looks much closer than it really is, but there is room for a hose to pass by the injector on the pass side.
and room right under the fuel line feed on the driver side. These hoses are going to go to a Y manifold and then into the TB. Just cant install all the hoses and stuff now bc i cant get to the top trans bolts with the valve covers on.
Also upgraded the factory steam vent set up to black AN set up to match the rest of the stuff on the car.
unfortunately the AN line from the vent to rad is smaller than the bung on the rad. So for now i have to run a reducer off the rad. Ordered up the correct barb to weld on the rad, will tackle that next time the rad is out. The reducer is fine for now.
