View Single Post
Old 08-06-2017, 08:12 PM   #2
V
Stalker
 
V's Avatar
 
Join Date: Aug 2004
Posts: 12,077
iTrader: (12)
What about doing something along the lines of the stage 8 locking fasteners? Where an extended point locks it in place.
Possibly make a rectangle out of sheet metal with tabs on each side. Then tighten down the nut and bend the side tabs up. As long as the extended side of the sheet metal tab will hit something to prevent spinning, then the nut shouldn't be able to spin either.
I dunno... it was the first idea that came to mind. lol.
Attached Images
File Type: jpg Untitled.jpg (14.6 KB, 2 views)
V is offline   Reply With Quote