Measured it as best as I could. Trans was pointing down 3* and rear was down 1*. so I shimmed the trans mount so it was pointing down 1* and rear pointing up 1* (as what my UMI angle finder said...)
It's still there, but its not as bad. I wonder if the angle finder just sucks and it's not getting an accurate reading... or my driveshaft may be too short since the car is lowered?
__________________
1986 Honda VFR750 - 89.3HP to the wheel
2000 Trans Am M6 - Mods: Yes.
2018 Durango R/T - AFE Intake, JLT Catch Can, Stainless Works Catback, Vinyl Dodge Racing Stripes
2003 Toyota Matrix XRS M6 - Lol
|