Progress has been slow with the jet drive taking a month to get delivered and then I needed to replace one of the cutlass bearings and decided to put a stainless impeller in with more pitch. Figuring out the marine specific parts to get and then locating them is more of a challenge than I thought. I just found out my order for the Glenwood straight exhaust risers was backordered for at least 4-5 weeks so I cancelled that order. I finally got the jet drive installed and hopefully sealed up properly, then I was able to install the engine after figuring out which motor mounts to use. The driveshaft h-bar was 1-1/2" short so I had to move the motor back. I still need to figure out the exhaust, get the engine wired, hook up the cooling, route the fuel system and then hope it doesn't leak!