NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post

LS1ow · 05-07-2019, 02:26 PM

after than i began to clean up the edges and clear all the paint off them to get a nice surface to weld on.

Then shaped some plates to cap off the holes.

and tac'd them in place.

and finally welded em in and welded up all the seams that were in the area while in there.

and now we are here.

05-07-2019, 02:26 PM	#2084
LS1ow Power Member / trans break does not equal transbrake Join Date: May 2009 Location: The Meadowlands Posts: 4,513 iTrader: (15) Social Networks:	after than i began to clean up the edges and clear all the paint off them to get a nice surface to weld on. Then shaped some plates to cap off the holes. and tac'd them in place. and finally welded em in and welded up all the seams that were in the area while in there. and now we are here. __________________ 99 Z28 - SBE LS1/60e Motor - 10.84 @ 128 - 1.47 60' Nitrous - 10.16 @ 132 - 1.40 60"