View Single Post
Old 05-26-2009, 10:28 PM   #8
PolarBear
Ebearnezer Scrooge/Power Member/Lips
 
PolarBear's Avatar
 
Join Date: May 2006
Location: Hamilton, Mercer county
Posts: 4,141
iTrader: (16)
Ehh welding sheet metal is easy and hard at the same time, basically you are just stringing a bunch of tack welds together so you dont heat the metal too much and warp it. And you dont want to blow holes in it at the same time, depending on how thin this can make a difference

Last edited by PolarBear; 05-26-2009 at 10:29 PM.
PolarBear is offline   Reply With Quote