NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post

siguy · 03-04-2010, 02:28 PM

Check is the lower rear control arms (if the bushing are bad the axle will move around throwing the pinion angle off ..

this is a long shot (because you said the rear was rebuild but check the pinion yoke on the rear axle (they are knonw to get loose (the crush sleeve) (you need to take the drive-shaft out and move it back in forth to see if its loose.) (you can push up on back of the driver shaft while in but, its easier to see if the crush Bearing is bad if the drive-shaft is out...

03-04-2010, 02:28 PM	#7
siguy Join Date: Sep 2009 Location: Staten Island, NY Posts: 206 iTrader: (2)	Check is the lower rear control arms (if the bushing are bad the axle will move around throwing the pinion angle off .. this is a long shot (because you said the rear was rebuild but check the pinion yoke on the rear axle (they are knonw to get loose (the crush sleeve) (you need to take the drive-shaft out and move it back in forth to see if its loose.) (you can push up on back of the driver shaft while in but, its easier to see if the crush Bearing is bad if the drive-shaft is out... __________________ 383 Motor with 9:1, P1SC Procharger and much more Last edited by siguy; 03-04-2010 at 02:32 PM.