View Single Post
Old 05-27-2009, 07:40 PM   #10
//<86TA>\\
Power Member
 
//<86TA>\\'s Avatar
 
Join Date: Oct 2007
Location: Milford NJ
Posts: 1,526
iTrader: (1)
if you do rent a machine, just get some metals of different thicknesses and play around with the welder. You wont be an expert right away, so dont get discouraged, you should be able to see whats happening to the materials at the different machine settings, ie no penetration, good penetration, slicing holes over-penetration. Give it some time and you will begin to figure it out.
//<86TA>\\ is offline   Reply With Quote