View Single Post
Old 03-30-2015, 11:05 AM   #4
LTb1ow
Mongo the Meet Coordinator
 
LTb1ow's Avatar
 
Join Date: May 2008
Posts: 16,892
iTrader: (8)
Part three, Rebirth of the unicorn

Sent crank and stuff out for polishing, and started to measure for bearings

Since the old cast cam was trash, I went with a billet cam from lunati

And with that, we have a rebuilt motor!


Link bar lifters will not come out with heads on, FYI

All done!

All the familar places, mated back to a trans and K

Went to town with even more heat wrap, if some is good, more must be better!

What more than likely killed the motor last time was solved with an ARP stud, and steel hold down.

And its back in!


Mounted up my PCM, it had previously just kinda sat on trans tunnel

Tackled wiring up gauges in hopes of stashing them where teh HVAC controls used to be


Finally, the official rebirth idle clip!


Some completed engine bay shots, had painted it during this time round

Wired up my BLS camaro LT1 HID kit


And that is where it stands today, few more nights of wrenching and should be able to start driving it again.
__________________
Quote:
Originally Posted by KirkEvil View Post
repo bigals turd gen and part it out to a loving home

Last edited by LTb1ow; 03-30-2015 at 11:21 AM.
LTb1ow is offline   Reply With Quote