View Single Post
Old 08-17-2015, 06:18 PM   #10
FlyingDutchman
 
FlyingDutchman's Avatar
 
Join Date: Dec 2008
Location: NNJ
Posts: 1,489
iTrader: (1)
Social Networks:

Quote:
Originally Posted by LTb1ow View Post
Either a header gasket leak, or rocker preload.

I would go over em all again, and just verify you have correct zero lash set, then whatever you wanted preload wise. I use 3/4 turn on mine.
Since noise was on driver side, pulled the cover again and all were good, except #1 intake was VERY loose. Since this was my first build and first time lashing valves prob didn't set poly lock on that one. Most likely loosened after yesterday's wot pulls. Will check passenger side and verify all are good. Thanks for the advice
__________________
1997 Camaro Z28 - 355 LT1, T56, CC503, LTs, ORY, Bald Eagle-back exhaust, !emissions, Lingenfelter CAI, EWP, !CAGS, BMR LCAs, UMI PHB, Koni Str.t/Koni SA, C5 Z06 front / LS1 F-body rear brake swap, factory hurst with short stick

2014 2LT Cruze 2.0 Turbo Diesel

Last edited by FlyingDutchman; 08-17-2015 at 06:20 PM.
FlyingDutchman is offline   Reply With Quote