[hardline_42]

I'm gonna get a head start on some basic suspension mods for my '93 Z28 and I'm planning some DIY lower control arms and panhard bar. I'm using 1.25" x .095" chromoly tubing, chromoly tubing adapters (gonna try my hand at MIG welding 4130, any pointers?) and Johnny Joints w/ welded studs and jam nuts. I need some dimensions from anyone who has adjustable LCA's or a PHB from Spohn, BMR, UMI et al. I need:

1) Rough eye-to-eye

2) Tubing out-to-out (including adapters)

3) Inside width of front and rear mounting brackets (frame/axle for PHB)

4) Dimensions of LCA relocation brackets on lowered applications

Thanks.