View Single Post
Old 11-07-2019, 12:17 PM   #71
BonzoHansen
Admin.
 
BonzoHansen's Avatar
 
Join Date: Aug 2005
Location: Hamilton, NJ
Posts: 20,149
iTrader: (27)
flat tappet cam? no no no no no no. its not 1989.

Amsoil makes 10/30 in their z-rod line. But with a roller cam it isn't really needed.

I have roughly 14.5" at idle and have no power brake issues.


Edit: above link is beat, i think it is this one. That says roller lifters.
http://nyesautomotive.net/406_525hp_EFI.html
"Erson hydraulic roller cam and lifters"
"This engine is fully machined, balanced, assembled, and dyno tested."

If the builder says 40 or 50 weight, he should know, he set the bearing clearances.
__________________
Vent Windows Forever!

The looser the waistband, the deeper the quicksand. Or so I have read.

Feather-light suspension, Konis just couldn't hold. I'm so glad I took a look inside your showroom doors.

Hey everybody, it's good to have you on the Baba-too-da-ba-too-ba-ba-buh-doo-ga-ga-bop-a-dop

Last edited by BonzoHansen; 11-07-2019 at 01:42 PM.
BonzoHansen is offline   Reply With Quote