View Single Post
Old 04-14-2006, 01:20 PM   #5
V
Stalker
 
V's Avatar
 
Join Date: Aug 2004
Posts: 12,077
iTrader: (12)
ok, if the tpi slave wont bolt up to the lt1 bellhousing, i found out that the tpi clutch hose will directly connect into the lt slave, so i wont have to change the master or line, whoohoo, this swap will be cake!

and in the process..i found the part i need to solve another t5 project dilema i was having. life is very good today.

Last thing now is figure out how long the T56 is compared to the T5 so i can figure out abotu the driveshaft and then how far away the trans mounts are located so i can make a t56 crossmember(or just buy one)
V is offline   Reply With Quote