|
After some more looking around, i found that an LT1 clutch disc is:
11.0" diameter, 1 1/8" 26 spline.
I found Ram clutch setups for like 290, and then id have to buy a flywheel too still. BUT... now i checked the size of a 83-92 clutch disc...that is:
10.5" diameter, 1 1/8" 26 spline
Only difference is the diameter, so that means the input shaft of the T56 will fit perfectly.
The motor is not putting out enough power yet where that .5" will make any difference.
Now as long as the lt1 bellhousing puts it at the correct depth and the pilot bearing fits, im all set almost. I just need to look into the cluthc slave issue now.
|