building a homebrew intake...inspection worries?
ok, i'm building a ghetto fabulous intake for my jeep using rubber couplers and PVC piping. however...i'm worried about what the folks at the inspection place will think of it. obviously it wont have a CARB sticker on it, etc, so should i worry?
I spoke with Alex (TransAm4life), and he said since my jeep is an '02 (obviously OBDII), they wont even do so much as open the hood, provided i dont throw any codes- which i wont.
lastly...what should i do regarding bends needed in the intake tube? i know they sell 90 degree bends, but that's the problem with them- they're 90 degrees, which hurts flow.
Thanks in advance,
Ryan
__________________
\'02 Graphite Metallic Jeep Grand Cherokee- 3.73's, intake, hi flow cat, poly rear sway bushings
\'02 Honda 250ex- Maxxis Razrs on Douglass .190 rims, custom velocity stack intake w/ UNI air filter, Pro Circuit Header, Pro Circuit T-4, 2 inch endcap, No spark arrestor, no quiet core, rejetted carb.....Turbo in the works
\'84 Honda Z50R- lots of new parts, new QA50 engine....sold 8/15/04
|