Just some parts i have laying around, 3rd and 4th gen stuff

[V]

ok, i moved some stuff around my garage and turned up a few parts i forgot i had...i'm posting a quick list of stuff off the top of my head. Â*If you want more info on an item(and condition) or need a specific part, PM me. If you want to know what will fit what, also PM me and i'll go over that. Â*I apologize for not listing prices for everything but due to the volume of parts it would take too long plus most will be very cheap just for me to get rid of them.

Exterior:
91 bird hatch
88 iroc hatch
85 firebird hatch
88 gta hatch
94 firebird hatch
87 z28 manual window doors, pair
91 firebird pass door
86 iroc pass door
88 gta doors, pair(need rust repair around handles)
94 firebird doors, pair
96 firebird doors, pair
93-02 firebird, t/a drivers door shells(2)
86 iroc pass fender
88 gta driver fender
85 firebird rear bumper
88 gta front bumper
88 gta rear bumper
88 gta front bumper (white, damaged, fixable?)
86 iroc rear bumper
85-92 camaro/firebird front and rear metal bumper impact bars
91 firebird hood (damaged, fixable?)
88 gta hood
88 gta hood black, needs paint
94 firebird hood
94 firebird pass headligth assembly w/cover
88 trans am tailights
94 firebird taillights
85-92 camaro grid taillights (2 sets and 2 pass)
88 gta headlights w/covers
88 gta windsheild wiper cowl, wiper arms, and wiper motor
82-87 wiper motors(2)
88 wiper motor, no delay
88 gta ground effects
91 firebird side ground effects
84 z28 side skirts
87 z28 3 piece spoiler pass side piece
86 iroc 1/4 ground effects
82-92 gas tank doors
88 iroc spoiler, 3 pedestal, low version
85-92 glass pass ttops(2)
85-92 lexan ttops pair with mounts to fit non lexan cars

Interior:
88 gta auto shifter and ebrake
94 firebird auto shifter and ebrake
91 firebird tan interior panels
94 firebird tan interior panels
88 gta grey interior panels
82-92 firebird dash pad
94 firebird tan headliner, hardtop
88 gta grey rear split seats
88 gta grey seat belts(no driver seat latch)
94 tan firebird seatbelts(complete i think)
82-02 rear view mirrors w/ or w/o lights
91 firebird center console, minor seperation
88 gta center console, some seperation as well
85-91 hatch pull down motors(5), not sure what years i have
88 gta steering column, FOR PARTS, auto w/steering wheel radio controls
86 iroc steering column w/ birdwheel, manual
88 iroc steering column w/wheel, manual
91 firebird steering column w/wheel, auto, airbag
94 firebird steering column w/wheel, auto w/radio controls
94 firebird complate dash shell, pass airbag intact
94 firebird gauge cluster, v6 auto
94 firebird climate controls

odd stuff:
several headlight and taillight harnesses from camaros and firebirds
82-92 3rd gen door switches and trim plates
82-89 window switches
cruise control setups, underhood
88 gta air intake ducts and air box
maf sensor
dual fan setups
single fan setups
tpi fuel rubber hoses
tpi base, tpi runners
88 iroc fuel rail
tpi 9th injector
88 iroc oil cooler, (no coolant lines)
350 roller block, .040 over, w/heads, no valvetrain
th350 tranny(2) 1 w/tq arm mount
ls1 heads
ls1 intake manifold
ls1 exhaust manifolds
85 z28 wheel front, 1
C4 vette rim, 1

more stuff i remembered...
94 firebird v6 ecm
94 firebird BCM
94 3.4 v6 throttle body
94 firebird v6 cruise control setup
93-02 camaro/firebird hartop door weatherstripping
93-02 hatch weatherstripping
82-92 hatch weatherstripping
02 ws6 rear sway bar
93-02 camaro amber turn signals
93-02 red rear side markers
93-02 clear side markers, w red bulbs
3rd gen blower fans
3rd gen climate controls(camaro or firebird styles)
92 camaro v6 dash cluster(missing tach and clear cover)
85-92 firebird dash trim
91-92 inside hatch rear brake light
91 firebird center caps(2 good, 1 missing logo)
hood latches w/ cable and handle
dash vents
82-92 firebird red rear side markers
random dipsticks and engine caps/tanks
odd and end body/interior bolts, clips, nuts, etc.
and several boxes of random smaller parts.

...Ok, i'm tired, thats all for now.
Thats a good amount of the parts I have, i doubt i could think of everything anyway. Â*PM me for prices, condition, and fitment.

[Savage_Messiah]

Did you ever get that 4th gen Camaro?

i need some window switches for my firebird im assuming thats what went bad

[NJSPEEDER]

you have a PM

[Trans Am Chick]

Originally Posted by NJSPEEDER

you have a PM

[BlueFBird]

u have a window motor for my 93 z28?

[Little G]

If you put all your parts together, how many cars would you have?

[78camaro]

Originally Posted by SmokingSS

ok, i moved some stuff around my garage and turned up a few parts i forgot i had

[V]

savage...not yet, but its there waiting for me as soon as i get time and room

86formula...switches could be the cause, i have a few laying around, i'll just give you a set for free.

bluefbird...both sets of doors(94 and 96) have motors in them which i could pull out, R&L are the same i believe for 93-02. also one of the door shells has one but thats been outside a while. Â*however, like i tell everyone asking about window motors, you may want to check ebay for brand new replacements, they range from $13-$25 with lifetime warrenty, which is better than i can say for a used motor. If i were to need a new motor myself, thats they way i'd go, JMO., but if you still want one, let me know.

littleG...not sure, but so far i've stripped over 20 f bodies. these are the parts remaining.

78camaro...well i didnt forget about ALL these parts, lol. just some, but it made me realized i had to advertise this stuff otherwise i'd run out of room to move in my garage. i didnt even mention the vette, monte carlo, eclipse, and bronco parts i have as well. Oh, and im still holding the 700r4 for you whenever your ready.

[Savage_Messiah]

hm how different are firebird and camaro 4th gen doors, do you have any red ones, and if i were to get one how hard would it be to wire in the power windows?

[V]

the door shells are different for the 4th gen f bodies, unlike the 3 rd gens where camaro and firebird can interchange. If you get a camaro door, to swap it, its just a matter of removing the door panel , unplugging all the wiring connectors in it, then unbolting it and bolting on the new door, plugging in all the new wires and reinstalling the door panel.

[Untamed]

The TPI and 350 stuff - with the parts you have, could I get close to building a complete 350 TPI for an 88 TA? Â*Not sure what else you have lying around that you might not have posted. Â*I have a working 700R4 already.

Also, off the 88 and 89 TA's, do you have an Aero-wing spoiler with few or no cracks and maybe the hatch struts? I don't need the whole hatch, just the spoiler and struts.

Thanks.

[V]

in order to build a full tpi system from what i have, you'd still need a plenum, throttle body, distributor, coil, wiring harness w/sensors, and vacuum lines. You could probably find a full setup for sale for cheaper than buying the parts piece by piece. the 350 i have is bored .040 over and just needs the cylinders honed and then new rings and bearings, i bought the engine like this and never fully checked it out, so i can't garuntee anything. but if i sell it and when completely opened up its obviously bad, i'll give a refund. I have an aero wing but the one arm is in pretty bad shape, maybe you could use fiberglass to rebuils it but i dunno, other than that the paint just flaked off but the back section is very solid. That hatch has the struts too but im not sure how good they are. sometimes you are better off buying new parts just to know what you are getting, JMO.

As for other parts, i honestly cant remember everything. I have cars i stripped years back and parts are still turning up. If you need somehting specific, let me know and then it should jog my memory to see if i have it. I stripped several cars down to the bare chassis so i should have just about anything, however the rare and more desireable parts from the past cars ive stripped may have been sold already.

[HardcoreZ28]

Is the 82-92 rear hatch weatherstripping new or used?

[V]

Originally Posted by HardcoreZ28

Is the 82-92 rear hatch weatherstripping new or used?

All the weatherstripping is used but in good condition and not cracked, dry, or torn.

[Untamed]

Third gen stock radio with equalizer and tape player? (stock resto needs), possibly an AC unit (climate control) and all the correct bezels for the dash. I'd prefer black, but would take medium gray if necessary.

Any third gen TA seats / seat covers? Would need both front and rears in god to excellent condition. Black prefered, but medium gray would work.

Need the prices to work into my budget, thanks.

[V]

untamed... i have a 3rd gen tape player with the eq, not sure if it works, i never checked it since it was in a car i stripped and nver powered up. ($10), i have the 85-92 climate controls for firebird($5) and with the dash trim, i have the grey instrument bezel($5). as far as i know all 85-92 were the grey color, and sorry no seat covers. I do have random other dash bezels for like the fog lights, W/ or w/o hatch button, rear defroster, etc, those i'd have to search for but i know have some, and those are grey as well. tell me the exact bezels you need and i can send you pics of what i have .



And for anyone interested,(i doubt it though), I would consider selling EVERYTHING in a package deal, there are at over 100 parts i have listed that are worth anywhere from 5-150 bucks each. This stuff is taking up to much space in my garage and yard and i need it gone. 2500 obo takes everything listed plus a bunch i didnt list. yeah i know thats a lot of money and you may say im crazy, but if you break it down to what everything could be sold for...its worth way more, make yourself money and sell this all on ebay, i just dont have the time anymore and need to clean house.

[formulaMARK]

I need the head light assembly thing. The plastic cracked and the head light will not go all the way up unless you hold the light in place. Let me kno if you have that piece. Thanks MARK.

[V]

formulaMARK,...what year is your car, and what side headlight?

[formulaMARK]

I have a 91 GTA. Driver side head light. You know the piece im talking about rite?

[V]

its the black triangular shaped piece that surrounds the headlight? and its held in by 4 torx screws? if thats hte piece i think i do have a drivers side out of a 91 bird, i just need to find it. ill look tomorrow.

[formulaMARK]

Ok thanks.

[LT!freak94]

hey man how much for the 93-02 clear corners with bulbs

[V]

they arent the front clear corners, they are the clears for the sides of the rear bumpers, i'd like to get 15 for them w/ the red bulbs(sorta look pinkish-red at night, but i got pulled over a few times when i had clear bulbs in them). I am only selling them since i changed my bumper to a euro version and it doesn have rear side markers anymore.

[formulaMARK]

When you find that part can you send me a pic?